Pyrotec A50B Bulk Cremator for Animals

Pyrotec A50B bulk cremator for animals

A50B - Bulk Animal Cremator

The Pyrotec A50 Bulk is a modern incinerator design to burn animal carcass waste in an efficient, clean and environmentally safe manner. Using the hot hearth principle of combustion, it is particularly suited for whole animal carcasses. The model is specifically for burning animal waste from abattoirs, research centres, waste contractors and animal crematoria and is equipped with the necessary sophistication of control, secondary chamber volume, manual or automatic loading options and chimney.

Description
  Models:   A50B
  Waste type:   Animal Carcass waste – calorific value 1,000 kcal/kg, density 700 kg/m³, moisture content 85%.
  Construction:   Mild steel fabrication construction using 5mm steel plate suitability braced and stiffened.
  Refractory:  Primary Chamber: Hot face material 1,600°C quality 150mm thick, backed by 75mm  calcium silicate insulation.
  Secondary Chamber: Hot face material 1,550ºC quality 80mm thick backed by 80mm of ceramic fibre insulation.
  Hot Hearth: High standard 1,600ºC 100mm thick tiles.
  Fuel:  Natural gas, LP gas or 35 seconds fuel oil.
  Electrical supply:  380/440 volt, 3 phase, 50/60hz.
  Burners:  Automatic package burners complete with electric ignition and flame failure control complete with all necessary valves, motors and integral continuous running fan.   Automatically temperature controlled to provide optimum combustion conditions, secondary chamber temperatures and fuel economy.
  Hot hearth: one at 200,000 kcal/hr on/off
  Primary Chamber: three at 200,000 kcal/hr on/off control
  Underchamber: two at 200,000kcal/hr on/off control sized to suit model
  Secondary Chamber: one at 185,000 kcal/hr on/off control
  Fans  All combustion and cooling air is provided by a common automatically controlled centrifugal fan, which provides air to nozzles strategically, located throughout the combustion chambers to ensure optimum conditions.
  Finish  One coat of primer followed by one coat of enamel finish in red.
 Control panel

  Automatic control system built to IEC standards incorporating plc controller, providing all automatic plant functions and incorporating the following sequences.

  1) Preheat 

  2) Burn cycle

  3) Burn down

  4) Cool down

The control panel will be equipped with an active mimic diagram showing operating status of the plant together with indication of primary, secondary chambers and exhaust temperatures.

  Monitors  The standard control system provides a digital display of the secondary chamber temperatures; however, in some instances the local DEFRA official may require the temperature to be permanently recorded by a dedicated chart recorder.

  Loading door

  A full size manually operated access door for waste loading.

  Deashing door

  Two dedicated manually operated access doors for underhearth deashing.