Pyrotec A50IC Individual Cremator for Animals

A50 IC 2

A50IC - Individual Animal Cremator

The Pyrotec A50IC is a modern incinerator designed to burn animal carcass waste in an efficient, clean and environmentally safe manner. The unit is configured to provide two adjacent cremator chambers, each being individually controlled for independent operation, using the hot hearth principle of combustion, it is particularly suited for animal crematoria and research centres and is equipped with the necessary sophistication of control, secondary chamber volume, manual loading and chimney.

  Models:    A50IC
  Waste type:    Animal Carcass waste – calorific value 1,000 kcal/kg, density 700 kg/m³, moisture content 85%.
  Construction:    Mild steel fabrication construction using 5mm steel plate suitability braced and stiffened.
  Refractory:   Primary Chamber: Hot face material high quality firebrick 114mm, backed by 75mm  calcium silicate insulation.
  Secondary Chamber: Hot face material 1,500ºC quality 112mm thick backed by 38mm of ceramic fibre insulation.
  Hot Hearth: High standard 1,600ºC 150mm thick.
  Fuel:   Natural gas, LP gas or 35 seconds fuel oil.
  Electrical supply:   380/440 volt, 3 phase, 50/60hz, 230 volt 1 phase, 50/60hz.
  Burners:   Automatic package burners complete with electric ignition and flame failure control complete with all necessary valves, motors and integral continuous running fan.   Automatically temperature controlled to provide optimum combustion conditions, secondary chamber temperatures and fuel economy.
  Primary Chamber: two at 200,000 kcal/hr on/off control
  Underchamber: two at 100,000kcal/hr on/off control sized to suit model
  Secondary Chamber: one at 350,000 kcal/hr on/off control
  Fans   All combustion and cooling air is provided by a common automatically controlled centrifugal fan, which provides air to nozzles strategically, located throughout the combustion chambers to ensure optimum conditions.
  Finish   One coat of primer followed by one coat of enamel finish in red.
 Control panel

  Automatic control system built to IEC standards incorporating plc controller, providing all automatic plant functions and incorporating the following sequences.

  1) Preheat 

  2) Burn cycle

  3) Burn down

  4) Cool down

The control panel will be equipped with an active mimic diagram showing operating status of the plant together with indication of primary, secondary chambers and exhaust temperatures.

  Monitors   The standard control system provides a digital display of the secondary chamber temperatures; however, in some instances the local DEFRA official may require the temperature to be permanently recorded by a dedicated chart recorder.

  Loading door

  Two automatically operated vertical doors that allow separate individual chamber cremation.

  Deashing door

  Two dedicated manually operated access doors for underhearth deashing.