Pyrotec General 2.3 General Incinerator Range

M100-CUT

Pyrotec General 2.3

The Pyrotec G is a modern incinerator designed to burn solid waste in a
clean and environmentally safe manner. Using the Pyrolytic principles of combustion, it is particularly suited for a wide range of waste material.
This model is specifically for burning general waste from factories,
offices, schools, Government departments and municipal refuse and is equipped with the necessary sophistication of control, secondary chamber volume and gas cleaning equipment to satisfy the most stringent environmental standards.

Description
  Models: G100, G150, G200, G250, G300, G350, G400 and G500.
  Waste type:

  General waste – Calorific value 4,000 KCal/Kg, density 50 to 100 Kg/m³.

  Type 0 waste: Calorific value 4,720 KCal/Kg.

  Type 1 waste: Calorific value 3,611 KCal/Kg.

  Type 2 waste: Calorific value 2,388 KCal/Kg.
  Construction: Mild steel fabricated construction using 6mm and 8mm steel plate suitably braced and stiffened.
  Refractory:   Primary Chamber: Hot face material 1,400ºC quality 115/150mm thick, backed by 76mm of Calcium silicate insulation.
  Secondary Chamber: Hot face material 1,600ºC quality 76/150mm thick, backed by 76mm Calcium silicate insulation.
  Fuel:  Natural gas, LP gas or 35 seconds fuel oil.
  Electrical supply: 380/440 Volt. 3 phase. 50/60Hz.
  Burners: Automatic package burners complete with electric ignition and flame failure control complete with all necessary valves, motors and integral continuous running fan. Automatically temperature controlled to provide optimum combustion conditions, secondary chamber temperatures and fuel economy.
  Primary Chamber: one @ 200,000 KCal/Hr on/off control.
  Secondary Chamber Secondary and Tertiary Chamber: two to four @ 200,000-500,000 KCal/Hr high/low control, sized to suit model.
  Fans All combustion and cooling air is provided by automatically controlled centrifugal fans which provide air to nozzles strategically located throughout the combustion chambers to ensure complete optimum conditions.
  Finish   Two coats of primer followed by two coats of enamel finish in burgundy.
 Control panel

  Automatic control system built to IEC Standards incorporating PLC controller, as necessary, providing all automatic plant functions and incorporating the following sequences.

  1. Preheat
  2. Burn Cycle
  3. Automatic loading
  4. Burndown
  5. Cooldown
  6. Ash removal

  The control panel will be equipped with an active mimic diagram showing operating status of the plant together with indication of primary, secondary and tertiary chambers and exhaust temperatures.

  monitors
  Particulate monitor. Carbon monoxide and Oxygen monitor. Six point chart recorder.
 

  loading door
  Vertical lifting hydraulically operated, sized to suit ram loading machine.

  loading
  Hydraulically powered automatic fully sequenced ram loader designed to operate in unison with the incinerator operation with programmable time and temperature operating sequence to ensure maximum throughput. Water sprays around the loader throat to quench the ram face following each loading sequence.
  Loading/ash removal door   Integral ash ram hydraulically operated and automatic in operation together with ash treatment zone allows for continuous ash removal throughout the burning cycle. Vacuum ash removal systems can be provided for single shift operation as an alternative.
  Heat recovery   Specifically designed waste heat recovery boilers can be incorporated to extract heat from the combustion gases and provide either hot water or steam.
  Alternative Chimney   When an existing or steel floor mounted chimney is to be used, exhaust gases will be cooled to 400ºC using a blower fan and cooling chamber prior to chimney entry.